When you are trying to set up the
new Netgear Arlo camera, then you may have to face synchronization obstacles.
Synchronization is one of the important things to look for the camera. If you
are getting the same difficulty, please go through the following
troubleshooting process or dial Arlo Support Phone Number.
So by following the below steps and accurate guidance, you can easily sync your
camera to the base station.
● Verify
whether your Arlo camera is placed within a maximum of three feet from the base
station. In case, it is not in this designated area, please obtain within the
prescribed limit. This is because if the base station is outside the maximum
specified range, then Arlo will not be able to sync.
● Make
sure the sync button was touched correctly or not. At the base station, the
sync button requires to be touched down for at least two seconds and after
that, you need to release. If the sync button was not pressed for at least two
seconds, then this can be the reason for sync problems. Also, ensure you have
pressed the sync button slightly when your security cameras & base stations
are adjacent to each other, to wit, within
three feet from each other.
● You
need to check the status of the Arlo camera batteries: check whether batteries
are properly aligned with the battery compartment. Make sure the battery is in
excellent condition. If the battery is over, bring the new battery and replace
the old one. If the battery is kept perfectly, that time, you need to check the
battery status by login to your particular Arlo account. You can see the
status of the battery by its icon which is placed on the top of the live camera
feed.
● Check
the status of Arlo the base station: Pass the following steps to check the
status of the Arlo camera base station.
● You
have to download the Arlo app. If you do not have an Arlo app, please visit
www.arlo.netgear.com and log in to the Arlo account.
● Click
on the "Settings" menu, place the option of "My Devices"
& tap on it.
● You
have to examine whether the base station is visible in the list of devices. If
the base station is not registered into the "My Devices" tab, please
add it to the device menu on your device. After the base station is registered,
again try syncing the Arlo security camera.
If you have followed all the
above-given steps, then you need to follow some more steps to sync your Arlo
camera. You should dial Arlo Support Number
for getting more possible help from the support team.
Steps
to sync the camera to the base station
● Press
and leave the base station's sync button for at least 2 seconds.
● Ensure
that, don’t press the button for more than two seconds. By mistake, it is
unexpectedly pressed for more than two seconds, then the light just in front of
the USB symbol will start clicking in yellow color. Then, you need to re-sync
the Arlo camera from the base station. Therefore, leave it approx for fifteen
minutes and once again press Sync option.
● You
need to keep your eye on the camera’s LED light that shows the position for the
synchronization. You need to wait until the LED blinks in green color.
● Now,
head towards the Arlo Security Camera Setup and hold the "Sync"
button accessible on Arlo for at least two seconds and release it after two
seconds.
● Wait
until the LED light of the Arlo camera is not blinking in blue color. Blueprint
of Blue Light will verify that your camera has accurately synced.
0 Comments