The Comprehensive Process To Set up the Arlo Security Camera

Arlo security camera gives you every several causes to buy it. When you are not at home, then you can see your visitor on your device by downloading the Arlo app. Also, this security system provides several features to keep secure your house and office. If you are going to buy this security system and you want to know how you can set Arlo Security camera, then you need to make a call on Arlo Support Number to know about the setup procedure. Support executives will also, provide you more information about this wire-free security system. 

Perform the steps to set-up & sync Arlo security camera

●     First, you need to unlock the Arlo camera battery compartment by holding & sliding the latch.

●     The, you need to slide the door of the Arlo camera battery & lift it for opening the compartment.

●     Now, you need to insert the battery & close the camera battery door.

●     You should place your security camera one to three feet from the base station.

●      Sync your Arlo camera from the base station.

# when you use the Arlo base station, then you need to press the sync button upon the side and you have to on back of the base station approx 2 seconds & release the button.

(Important Note- when you press the Arlo camera sync button upon the Arlo base station for a long time, then the LED in the USB symbols will blink amber approx 10 minutes. When the USB LED blinks amber, that means your sync process will be blocked.)

# When you use the Arlo pro base station, then you need to hit the button upon the base station approx 2 seconds & after some time you have to release the button.

●     You have to sync the status LED until blink green in color.

●     Then you have to press the sync button on the upper side of the Arlo camera approx 2 seconds & then release the sync button.

●     For confirming the sync, a blue LED on the security camera blinks continuously. That time, you need to repeat the process. If you are getting confused about this, then dial Arlo Support Phone Number.

●     Now, on the base station, you need to check the Arlo security camera LED.

●     If you see the Arlo camera LED upon the base station blinks in green color, then your sync procedure has completed.

●     You should repeat this procedure for each Arlo camera. (Important note- when the sync process does not complete under one minute, then you have to press the sync button on the Arlo camera base station and try this process again.

Hope this information will be quite sufficient for you. Still, you have any confusion & you are getting issues while applying these methods, then you should make a call on Arlo Camera Tech Support Phone Number. Here you can directly ask anything from the Netgear certified executives.